
Page 3-48 G1000 System Maintenance Manual – Diamond DA40/40F
Revision G 190-00545-01
8. If an error occurs during synchronization, one of the following messages will be displayed
followed by the affected GDU:
Err No Space - SD card does not contain sufficient memory
Timeout – system timed-out prior to the database transfer completing
Canceled - an active synchronization has been cancelled due to the SYNC DBS softkey
being unselected
Err – displayed for all other errors
Note that a power cycle is required to restart synchronization when ‘Err No Space’ or ‘Err’ is
shown.
9. When the synchronization is complete, the status is shown as ‘Complete’.
10. Cycle power to the PFD and MFD.
11. On the AUX – SYSTEM STATUS page, press the MFD1 DB softkey. Scroll through all of the
databases contained in the MFD and confirm that the correct databases are loaded.
12. Press the MFD1 DB softkey again to toggle to PFD1 DB. Scroll through all of the databases
contained in the PFD1 and confirm that the correct databases are loaded.
13. Remove the navigation database update card from the MFD.
3.5.19 Clearing Default User Settings
1. Remove power from PFD and MFD by pulling the PFD and MFD circuit breakers.
2. While holding the CLR button on PFD, reset PFD circuit breaker.
3. When prompted to clear user settings, select the YES softkey
4. While holding the CLR button on the MFD, reset the MFD circuit breaker.
5. When prompted to clear user settings, select the YES softkey.
Kommentare zu diesen Handbüchern