Garmin Software Version 0321.23 Handbuch Seite 50

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 266
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 49
Page 3-6 G1000 System Maintenance Manual – Diamond DA40/40F
Revision G 190-00545-01
3.3.1 SET>ACTV Configuration
Throughout the configuration mode pages, there are SET and ACTIVE columns for input/output settings
and other parameters.
SET:
Refers to a setting or group of settings that reside in PFD internal memory.
ACTIVE: Refers to a current setting stored and used in a LRU. LRUs store the ‘active’ settings
within internal memory.
Data can be manually copied from one column to the other (and consequently from PFD memory to the
LRU memory and vice-versa) by using the following two softkeys, when available:
SET>ACTV (read ‘Set to Active’) softkey: Allows the technician to send the information in the SET
column (data stored in PFD internal memory) to the ACTV column (data used by LRU).
ACTV>SET (read ‘Active to Set’) softkey: Causes the LRUs current settings to be copied to PFD
internal memory as SET items.
CAUTION
It is highly recommended that the ACTV>SET softkey not be used unless specifically
instructed by this manual. If the ACTV>SET softkey is used it should be used with
caution! If an improperly configured unit is installed, this softkey causes the wrong
configuration to replace the correct aircraft configuration.
In the first example shown in Figure 3-10, the SET columns do not match the ACTIVE columns. The
inequality between SET and ACTIVE indicates a configuration mismatch and triggers a configuration
error message for the LRU. By pressing the SET>ACTV softkey, this copies the data shown in the SET
column to the LRU unit’s internal memory. The settings then become the ACTIVE settings for the LRU
being configured.
Seitenansicht 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 265 266

Kommentare zu diesen Handbüchern

Keine Kommentare