Garmin Software Version 0321.23 Handbuch Seite 114

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 266
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 113
Page 4-22 G1000 System Maintenance Manual – Diamond DA40/40F
Revision G 190-00545-01
4.9 Flap Position Discrete Input Check
4.9.1 (SW v0321.19 or earlier) Flap Position Discrete Input Check
To perform this check, all G1000 and GFC 700 equipment must be installed and operational. Start the
G1000 system in Configuration Mode and go to the GIA Page Group and select the GIA I/O
Configuration Page using the FMS knob. Perform the following checks:
Figure 4-10. (SW v0321.19 or earlier) GIA I/O Page
1. Extend the flaps down. While the flaps are traveling down, check that the discrete input labeled
‘FLAP EXTEND’ lights up green.
2. Retract the flaps up. While the flaps are traveling up, check that the discrete input labeled ‘FLAP
RETRACT’ lights up green.
3. Restart the G1000 system in normal mode. Wait until the AHRS and ADC systems come online
and for the AFCS Pre-flight Test to complete.
4. Press the FD key on the MFD to engage the Flight Director. Press the AP key to engage the
Autopilot. Press the CWS button for a few seconds and release; verifying there is no residual
force on the control stick for the pitch axis.
5. Extend the flaps to approach position. The trim wheel should immediately run in the DOWN
direction. Now retract the flaps. The trim should immediately run in the UP direction.
6. Disengage the autopilot system.
7. The flap discrete input check is complete.
Seitenansicht 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 265 266

Kommentare zu diesen Handbüchern

Keine Kommentare