Garmin Software Version 0858.09 Bedienerhandbuch PDF herunterladen (Seite 78)

Page 8-12 G1000 System Maintenance Manual - Hawker Beechcraft G36

Rev. 5 190-01259-00

j. Release the CWS button and verify that servo clutches re-engage before releasing

the control wheel.

k. Press the NOSE DN key on the MFD twice. Verify that the command bars command

down and the control wheel begins moving forward.

l. Hold the controls and press CWS to re-center the command bars and stop control

wheel movement.

m. With the Autopilot still engaged and the CWS button pressed, move the control

wheel to its aft limit.

n. Release the CWS button and apply continuous forward pressure, slowly moving the

control wheel. After 1 or 2 seconds, the trim wheel should begin moving in a trim up

direction.

o. Grip the control wheel and press the CWS button. Trim motion should stop.

p. Move the control wheel to the forward limit and release the CWS button.

q. Slowly pull back on the control wheel. After a similar delay, the trim wheel should

begin to trim down.

r. Relieve pressure on the wheel and the trim motion should stop. Verify that the trim

wheel is free to turn.

s. Hold the control wheel and press the AP DISC switch to disconnect the Autopilot.

t. Engage VS mode by pressing the VS key on the MFD. Verify the PFD display ‘VS’

in green and indicates a pitch reference of ‘0 FPM’.

u. Press the ALT key on the MFD and verify that the ‘ALT’ annunciation is displayed in

green on the PFD with an altitude reference equal to the aircraft altitude (within the

nearest 20 feet).

v. Press the FD key and verify that the mode annunciations and command bars are

removed from the display.

NOTE

To fully verify the yaw damper function, it must be checked in flight.

w. Press the YD key and verify that the ‘YD’ annunciation is displayed in green on the

PFD.

x. Press the rudder pedals and verify that the yaw servo is resisting movement of the

rudder pedals.

y. Press the AP DISC button and verify that a flashing yellow ‘YD’ annunciation is

displayed on the PFD.

z. Verify that the rudder pedals move freely.

1 2 ... 73 74 75 76 77 78 79

Keine Kommentare

Garmin Software Version 0858.09 Bedienerhandbuch Seite 78