
Page 7-12 G1000 System Maintenance Manual - Hawker Beechcraft G36
Rev. 5 190-01259-00
o. Toggle intruder traffic to standby or off.
p. Reposition ramp test set and directional antenna to an aft position of 180 degrees.
q. Reengage the same intruder scenario as above.
r. Verify a target is annunciated on the MAP-TRAFFIC MAP page of the MFD at the correct
bearing of approximately 180 degree azimuth at 2 NM and co-altitude.
s. Toggle intruder traffic to standby or off.
t. Reposition ramp test set and directional antenna to a port position of 270 degrees.
u. Reengage the same intruder scenario as above.
v. Verify a target is annunciated on the MAP-TRAFFIC MAP page of the MFD at the correct
bearing of approximately 270 degree azimuth at 2 NM and co-altitude.
w. Toggle intruder traffic to standby or off.
x. If the bearing is not as anticipated, or multiple targets are displayed during tests, recheck the
antenna coaxial connections by verifying the following:
• QMA connectors are 'snapped' firmly in place
• Connections are made to the proper channels and color-coded heat shrink is the
same color on both ends of cable
• QMA connectors are correctly installed on cables
• Correct antenna type is selected in the configuration
Kommentare zu diesen Handbüchern