Garmin Software Version 0858.09 Bedienerhandbuch PDF herunterladen (Seite 58)

Page 6-4 G1000 System Maintenance Manual - Hawker Beechcraft G36

Rev. 5 190-01259-00

NOTE

Failure of the GRC 10 (i.e. dead batteries) has no impact on normal

aircraft operations and is only used for passengers to control audio

entertainment.

NOTE

It is not necessary to reconfigure GRC 10 after battery replacement.

6.5 GDU Removal & Replacement

Removal:

1. Make sure all airplane electrical power is disconnected.

2. Using a

hex tool, turn all four

-turn fasteners, on the display unit, counter-clockwise

until they reach their stops.

NOTE

The display unit harness is protected by a flexible chain link conduit that

protects the harness and eases the retraction of the harness back into

the rack when installing the display unit.

3. While supporting the display unit, carefully pull the unit aft to access the single harness

connector.

Reinstallation:

1. Remove the protective caps from the display unit and harness connectors. Visually

inspect the display unit harness connector for damage. Repair any damage.

2. While supporting the display unit, connect the harness connector to the rear of the

display unit.

NOTE

The display unit harness is protected by a flexible chain link conduit that

protects the harness and eases the retraction of the harness back into

the rack when installing the display unit.

3. Carefully insert the display unit into the panel cutout. Make sure all four

-turn fasteners

align with the corresponding panel holes.

4. Seat the display unit in the panel cutout. Do not use excessive force.

5. Once the display unit is seated, turn all four

-turn fasteners clockwise to lock the

display unit to the instrument panel.

6. If display is new, perform software loading and configuration of display in accordance

with the steps beginning in Section 3.7.1.

7. If display is existing, proceed to Section 8.1 for display checkout.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 78 79

Keine Kommentare

Garmin Software Version 0858.09 Bedienerhandbuch Seite 58