Garmin Software Version 0858.09 Bedienerhandbuch PDF herunterladen (Seite 33)

G1000 System Maintenance Manual - Hawker Beechcraft G36 Page 3-15

190-01259-00 Rev. 5

3.7.4 GRC 10 configuration (Optional)

For installations with the optional GRT 10/GRC 10 wireless remote system, the GRC 10 must

be configured to communicate with the specific GRT 10 that is installed in the aircraft. To

configure the RF Pairing ID of the GRC 10:

NOTE

GRT 10 serial number is required for installation. Serial number is

located on the bottom of the unit.

a. Insert two AA batteries in GRC 10.

b. On the GRC 10 press any key to power the remote.

c. When the “GRT 10 not found” message is displayed on the GRC 10, press the following

buttons in order:

UP, DOWN, LEFT, RIGHT, MINUS (-), PLUS (+), PSET

d. Use the arrow buttons on the GRC 10 to enter the serial number of the GRT 10 transceiver

that is installed in the aircraft. Verify that the correct GRT 10 transceiver serial number has

been entered.

e. Press the XM button to store the GRT 10 serial number.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 78 79

Keine Kommentare

Garmin Software Version 0858.09 Bedienerhandbuch Seite 33