Garmin Software Version 0858.09 Bedienerhandbuch PDF herunterladen (Seite 55)

G1000 System Maintenance Manual - Hawker Beechcraft G36 Page 6-1

190-01259-00 Rev. 5

6 EQUIPMENT REMOVAL & INSTALLATION

This section describes how to remove and replace equipment in the G36 that was installed as

part of this STC. After removal and replacement, LRUs must be configured and tested as

described in Section 7. For removal and replacement instructions for all other G1000 / GFC

700 equipment, refer to existing Hawker Beechcraft G36 Maintenance Supplement listed in

Table 1.1.

CAUTION

When removing and/or replacing any G1000 component, always

ensure that aircraft power is off. Unplug any auxiliary power

supplies. Unplug the aircraft battery. Before performing

maintenance, it is required that the technician verify the LRU

software part number and version number matches the software

configuration listed in the General Arrangement Drawing 005-

00620-06, listed in Table 1.1.

To check an LRU software part number and/or version, follow the procedure defined in Section

3.7.

If a faulty LRU is not reporting its software version and part number, check aircraft maintenance

logs for last software version loaded and verify against the General Arrangement Drawing 005-

00620-06. The Software Manifest page may also be used to check part numbers and versions.

6.1 GTS 820 TAS Processor

CAUTION

After any maintenance or modification is made to the GTS 820 TAS

cables such as replacing a connector or entire cable, some important

considerations must be made.

Be sure to adhere to all of the specifications and limitations such as

minimum and maximum cable attenuation, attenuation balance between

cables, phase matching etc. in the Installation Manual referenced in

Table 1.2.

Removal:

1. Gain access to the tail section.

2. Disconnect the eight coax “quick-lock” connectors.

3. Disconnect the three electrical connectors.

4. Unlock the unit from the rack by loosening the ratcheting latch mechanism.

5. Remove the unit from the rack.

Reinstallation:

1. Inspect the connectors for damaged pins.

2. Insert the unit into the installation rack.

3. Lock the unit into the rack by using the ratcheting latch mechanism.

4. Reconnect the eight coax “quick-lock” connectors and the three electrical connectors.

5. Configure and test the GTS 820 according to 7.1.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 78 79

Keine Kommentare

Garmin Software Version 0858.09 Bedienerhandbuch Seite 55