Garmin Software Version 0858.09 Bedienerhandbuch PDF herunterladen (Seite 21)

G1000 System Maintenance Manual - Hawker Beechcraft G36 Page 3-3

190-01259-00 Rev. 5

3.4 Configuration Mode Overview

The Configuration Mode exists to provide the avionics technician with a means of configuring,

checking, and calibrating various G1000 sub-systems. Troubleshooting and diagnostics

information can also be viewed in this mode.

To start the system in Configuration Mode:

a. Press and hold the ENT key on the MFD while resetting power using the MFD circuit

breaker.

b. Release the ENT key after ‘INITIALIZING SYSTEM’ appears in the upper left corner of the

MFD.

c. Press the ENT key or the YES softkey to update system files if prompted.

d. Repeat steps a through c on the PFD using the PFD circuit breaker to apply power.

CAUTION:

The Configuration Mode contains certain pages and settings that are critical to

aircraft operation and safety. These pages are protected and cannot be

modified, unless the technician is properly authorized and equipped. However,

most protected pages are viewable to allow system awareness for

troubleshooting.

NOTE

For a complete description and breakdown of each Configuration Mode page,

refer to the G1000 System Maintenance Manual listed in Table 1.2.

3.5 Configuration Mode Navigation

Using the FMS knob, a user can navigate through different pages and page groups in the

Configuration Mode. For complete description and breakdown of each page, refer to the G1000

Line Maintenance & Configuration manual.

System Page Group

1. System Status 6. File Manager 11. System Setup

2. Time Configuration 7. Diagnostics Terminal 12. Manifest Configuration

3. Lighting Configuration 8. OEM Diagnostics 13. Maintenance Log

4. System Audio 9. System Configuration

5. System Upload 10. System Data Path Configuration

GDU Page Group

1. Serial Configuration 4. Diagnostics 7. Airframe Configuration

2. CDU Status Page 5. Ethernet Test 8. TAWS Configuration

3. Key Test 6. Alert Configuration

GIA Page Group

1. Serial Configuration 3. GIA I/O Configuration 5. GIA Status Page

2. GIA RS-485 Configuration 4. GIA Configuration 6. GIA CAN Configuration

GEA Page Group

1. Engine Data 2. GEA Status Page 3. GEA Configuration

GTX Page Group

1. Serial Configuration 2. Transponder Configuration

GRS Page Group

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 78 79

Kommentare zu diesen Handbüchern

Keine Kommentare

Garmin Software Version 0858.09 Bedienerhandbuch Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Navigatoren Garmin Software Version 0858.09