Garmin Legacy Software Versions Betriebsanweisung Seite 288

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 364
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 287
Garmin G1000 Pilot’s Guide for Cessna Nav III 190-00498-00 Rev. A8-10
If the
KTA 870
successfully completes self-test, a
synthesized voice announces: “TAS SYSTEM OK”. The
unit should switch to OPERATE mode at the completion
of the test. Should a failure be detected during self-test,
the audio message says: “TAS SYSTEM FAIL”. The unit
should revert back to STANDBY mode if a self-test failure
is detected.
TAS VOICE ANNOUNCEMENTS
See the KTA 870 Pilot’s Guide for information on voice
announcements.
To begin tracking intruder aircraft:
Press the
OPERATE
softkey.
SWITCHING BETWEEN STANDBY AND
VARIOUS OPERATING MODES
The unit must be in operating mode for traffic to be
displayed. The ability to switch out of standby into oper-
ating mode on the ground is especially useful for scanning
the airspace around the airport before takeoff.
To switch into Operating Mode from
Standby Mode:
1. Press the
OPERATE
softkey or menu ‘Operating
Mode’.
2. If ‘Operating Mode’ is selected from the FMS
menu, press the
ENT
key to confirm and place
the KTA 870/KMH 880 in operating mode.
To switch into Standby Mode from the
Traffic Page:
Press the
STANDBY
softkey.
ALTITUDE DISPLAY MODE
To change the Altitude Display Mode:
1. Press the
ALT MODE
softkey then press one of
the following options: BELOW, NORMAL, ABOVE,
UNREST.
With each selection, the screen changes to display the
traffic detected within the selected altitude display range.
The G1000 screen also displays unrestricted traffic (UN-
REST) having a range of maximum specified by the KTA
870 Pilot’s Guide. Refer to the KTA 870 Pilot’s Guide for
information regarding altitude display ranges. Note that
confirmation is not required. The mode is changed im-
mediately when selected.
TRAFFIC MAP PAGE DISPLAY RANGE
The pilot can change the display range on the Traffic
Map Page at any time.
To change the display range on the Traffic
Page:
1. Turn the RNG knob to zoom through the following
range options:
Bendix/King KTA 870—2 nm, 2 and 6 nm, 6 and
12 nm, 12 and 24 nm, and 24 and 40 nm.
OPTIONAL EQUIPMENT
Seitenansicht 287
1 2 ... 283 284 285 286 287 288 289 290 291 292 293 ... 363 364

Kommentare zu diesen Handbüchern

Keine Kommentare