Garmin GPS 500 Bedienungsanleitung PDF herunterladen (Seite 203)

GPS 500 Pilot’s Guide and Reference

12-15

SECTION 12

ADDITIONAL FEATURES

Switching Between Standby and Operating

Modes

The unit must be in operating mode for trafﬁc to be

displayed. The ability to switch out of standby into operating

mode on the ground is especially useful for scanning the

airspace around the airport before takeoff. Operating Mode

is conrmed by the display of ‘OPER’ in the upper right-

hand corner of the Trafc Page (Figure 12-22).

Switching to Operating Mode from Standby

Mode:

1) Press the small right knob to activate the

cursor and highlight ‘STBY’.

2) Turn the small right knob to select ‘OPER?’.

3) Press the ENT Key to conﬁrm and place the

GTS 8XX in operating mode, the GTS 8XX

switches out of standby into the 6-nm display

range.

NOTE: The GTS 8XX will automatically switch out

of standby 8 to 10 seconds after takeoff, which

is determined by ground speed or by a transition

of the aircraft squat switch (if connected).

Switching to Standby Mode from the Trafﬁc

Page:

1) Press the small right knob to activate the

cursor and highlight ‘OPER’.

2) Turn the small right knob to select ‘STBY?’.

3) Press the ENT Key to conﬁrm and place the

GTS 8XX in standby mode.

NOTE: The GTS 8XX goes into standby mode 24

seconds after landing, which is determined by

ground speed or by a transiton of the aircraft

squat switch (if connected). This delay allows

the GTS 8XX to remain out of standby during a

touch-and-go maneuver.

Trafﬁc Page

Trafc can be displayed both on the Map Page (only

if heading is available) and on the Trafc Page (Figure

12-22). The orientation source shown at the top of the

display rst uses heading (‘HDG’), then GPS Track (‘TRK’)

if no heading is available, to orient the display.

If the GTS 8XX does not have bearing information for

an active TA, ‘TA’ followed by range, relative altitude, and

altitude trend is displayed in the lower right corner. The

Trafc Banner is displayed if more than one TA with no

bearing info is active, while the TA of most immediate

threat is displayed in text below the banner.

Figure 12-22 Trafﬁc Page

Orientation Source

Trafﬁc Advisory

(with no bearing

information)

Display

Range

Operating Mode

Trafﬁc

Trafﬁc Banner

Trafﬁc Page Display Range

The display range on the Trafﬁc Page can be changed

at any time.

Changing the display range on the Trafﬁc

Page:

Press the RNG Key to step through the

following range options:

• 2 nm

• 2 and 6 nm

• 6 and 12 nm

• 12 and 24 nm (GTS 820/850 only)

• 24 and 40 nm (GTS 820/850 only)

190-00181-60 Rev. G

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 255 256

Kommentare zu diesen Handbüchern

Keine Kommentare

Garmin GPS 500 Bedienungsanleitung Seite 203

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Luftausrüstung Garmin GPS 500