Garmin GPS 500 Bedienungsanleitung PDF herunterladen (Seite 157)

GPS 500 Pilot’s Guide and Reference

8-23

SECTION 8

AUX PAGES

Setting the arrival alarm and alarm

distance:

1) Select ‘CDI/Alarms’ from the Setup Page, using

the steps described at the beginning of this

section.

2) Turn the large right knob to highlight the

‘On’/’Off’ ﬁeld (directly below ‘Arrival Alarm’).

3) Turn the small right knob to select ‘On’ or

‘Off’, as desired. Press the ENT Key to accept

the selection.

4) The ﬂashing cursor moves to the alarm distance

ﬁeld (to the immediate right of ‘On’ or ‘Off’).

To enter an arrival alarm distance, use the small

and large right knobs to enter the desired

alarm distance. Press the ENT Key when

ﬁnished.

NOTE: The CDI scale is always measured in

nautical miles, regardless of the current distance

units of measure selected on the Units/Position

Page.

Setup Page: Units/Position

Setting the magnetic variation:

1) Select ‘Units/Position’ from the Setup Page,

using the steps described at the beginning of

this section.

2) The ﬂashing cursor highlights the heading

mode ﬁeld. Turn the small right knob to select

the desired heading mode: Auto, True, or User

(Figure 8-35). Press the ENT Key to accept the

selection. (The heading modes are described

at the beginning of this section.)

Figure 8-35 Heading Mode Window

3) If ‘User’ is selected, the ﬂashing cursor moves

to the user value ﬁeld (to the immediate right of

‘User’). Use the small and large right knobs to

enter the desired magnetic variation direction

and value. Press the ENT Key when ﬁnished.

190-00181-60 Rev. G

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 255 256

Keine Kommentare

Garmin GPS 500 Bedienungsanleitung Seite 157