Garmin GPS 500 Bedienungsanleitung PDF herunterladen (Seite 87)

GPS 500 Pilot’s Guide and Reference

SECTION 5

PROCEDURES

5-15

Refer to Figure 5-35 for the following steps.

3) Within 30 nm of KTOP, the GPS 500 switches

from enroute mode to terminal mode and the

CDI scale transitions from 5.0 to 1.0 nm, full

scale deﬂection.

4) If the approach has not yet been activated

(in step 2 above), do so when cleared for the

approach (Figure 5-36).

Figure 5-36 Procedures Page

5) When approaching the IAF (D258G), a waypoint

alert (‘NEXT DTK 353°’) appears along the

bottom of the screen. As the distance (DIS) to

the IAF approaches zero, the alert is replaced

by a turn advisory (‘TURN TO 353°’).

6) Follow the arc, when the course select setting

and desired track differ by more than 10°, a

‘Set course to ###°’ message appears on the

Message Page (Figure 5-37).

Figure 5-37 Message Window

7) The next point in the approach is an intermediate

ﬁx, labeled ‘D025G’. When approaching this

intermediate ﬁx, a waypoint alert (‘NEXT DTK

205°’) appears along the bottom of the screen.

As the distance to this ﬁx approaches zero, the

alert is replaced by a turn advisory (‘TURN TO

205°’). Dial this course into the CDI (or HSI)

using the OBS knob.

8) At 2.0 nm from the FAF (TOP VOR), the GPS

500 switches from terminal mode to approach

mode. CDI scaling is tightened from 1.0 to 0.3

nm, full scale deﬂection.

190-00181-60 Rev. G

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 255 256

Keine Kommentare

Garmin GPS 500 Bedienungsanleitung Seite 87