Garmin Software Version 0563.32 Betriebsanweisung Seite 95

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 182
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 94
Garmin G1000 Cockpit Reference Guide for the Cessna Nav III
190-00384-13 Rev. B 77
Hazard Avoidance
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
NOTE: Pilots should be aware of TAS system limitations. TAS systems
require transponders of other aircraft to respond to system interrogations.
If the transponders do not respond to interrogations due to phenomena
such as antenna shading or marginal transponder performance, traffic may
be displayed intermittently, or not at all. Aircraft without altitude reporting
capability are shown without altitude separation data or climb descent
indication. Pilots should remain vigilant for traffic at all times.
System Self Test
1)
Turn the large FMS Knob to select the Map Page Group.
2)
Turn the small FMS Knob to select the Traffic Map Page.
3)
Turn the RANGE Knob to set the range to show an inner diameter of 2 nm
and an outer diameter of 6 nm.
4)
Press the STANDBY Softkey.
5)
Press the TEST Softkey.
6)
Self test takes approximately eight seconds to complete. When completed
successfully, traffic symbols display and a voice alert “Traffic Advisory
System Test Passed” is heard. If the self test fails, the system reverts to
Standby Mode and a voice alert “Traffic Advisory System Test Failed” is
heard.
Enabling/Disabling Flight ID Display
On the Traffic Map Page, press the
FLT ID
Softkey.
Displaying Traffic on the Traffic Map Page
1)
Turn the large
FMS
Knob to select the Map Page Group.
2)
Turn the small
FMS
Knob to select the Traffic Map Page.
3)
Press the OPERATE Softkey to begin displaying traffic. OPERATING is
displayed in the Traffic mode field.
4)
Press the ALT MODE Softkey to change the altitude volume.
5)
Press the STANDBY Softkey to place the system in the Standby mode.
STANDBY is displayed in the Traffic mode field.
6)
Turn the RANGE Knob clockwise to display a larger area or counter-
clockwise to display a smaller area.
Seitenansicht 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 181 182

Kommentare zu diesen Handbüchern

Keine Kommentare