
Garmin G1000 Cockpit Reference Guide for the Cessna 350/400
190-00567-01 Rev. B
1-9
SECTION 1
SYSTEM OVERVIEW
ALT UNIT
– Displays softkeys for setting the
altimeter and BARO settings to metric units:
METERS
– When enabled, displays altimeter in
meters.
IN
– Press to display the BARO setting as inches
of mercury.
HPA
– Press to display the BARO setting as
hectopacals.
STD BARO
– Press to set the barometric pressure
to standard pressure.
BACK
– Press to return to the previous level softkeys.
ALERTS
– Press to display the Alerts Window.
OBS – Press to select OBS Mode on the CDI when
navigating by GPS (only available with active leg).
CDI – Press to change navigation mode on the CDI
between GPS, VOR1, and VOR2.
XPDR – Press to display the transponder mode
selection softkeys.
STBY
– Press to select Standby Mode.
ON
– Press to select Mode A.
ALT
– Press to select Altitude Reporting Mode.
GND
– Press to select Ground Mode.
VFR
– Press to automatically squawk 1200 (only
in the U.S.A., refer to ICAO standards for VFR
codes in other countries).
Press the BACK Softkey to return
to the top-level softkeys.
Press the BACK Softkey to return
to the top-level softkeys.
ALERTS
ALERTS
ALERTS
Figure 1-6 XPDR (Transponder) Softkeys
CODE
– Press to display transponder code selection
softkeys 0-7.
0 through 7
– Press numbers to enter code.
IDENT
– Press to provide special aircraft
position identification to Air Traffic Control
(ATC).
BKSP
– Press to remove numbers entered one
at a time.
BACK
– Press to return to the previous level
softkeys.
IDENT
– Press to provide special aircraft position
identification to Air Traffic Control (ATC).
BACK
– Press to return to the previous level
softkeys.
ALERTS
– Press to display the Alerts Window.
IDENT – Press to provide special aircraft position
identification to Air Traffic Control (ATC).
TMR/REF – Press to display the Timer/References
Window.
NRST – Press to display the Nearest Airports
Window.
ALERTS – Press to display the Alerts Window.
Kommentare zu diesen Handbüchern