Garmin Software Version 0719.00 Betriebsanweisung Seite 59

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 228
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 58
Garmin G1000 Cockpit Reference Guide for the Socata TBM 850
190-00708-00 Rev. A
4-3
SECTION 4 – NAV/COM &
TRANSPONDER
4.1 RADIO STATUS INDICATIONS
RX – When a COM signal is received, a white ‘RX’
appears by the active COM frequency during signal
reception.
TX When a COM radio is transmitting, a white ‘TX’
indication appears to the right of the corresponding
COM frequency.
ID When the Morse code identifier is ON for a NAV
radio, a
white ‘ID’ indication appears to the left of
the corresponding active NAV frequency. The Morse
code identifier can be heard if the corresponding
NAV radio is selected on the audio panel.
Figure 4-5 Radio Status Indications
4.2 VOLUME
‘VOLUME’ is displayed in place of the associated radio
name (i.e., ‘COM1’ or ‘NAV2’) for two seconds after the
volume level is last changed. The percentage of maximum
volume is displayed in place of the standby frequency
selected by the tuning box.
Figure 4-6 COM Volume Level
4.3 AUTOMATIC SQUELCH
Automatic squelch can be disabled for a COM radio by
pressing the COM Knob to place the tuning box on the
desired COM’s standby frequency, then by pressing the
VOL/PUSH SQ Knob.
4.4 QUICKLY ACTIVATING 121.500 MHZ
Pressing and holding the COM Frequency Transfer
Key for approximately two (2) seconds automatically tunes
the selected COM radio to the emergency frequency.
4.5 OPTIONAL NAV RADIOS
The ADF/DME Tuning Window is displayed by
selecting the ADF/DME Softkey.
ADF Radio (optional)
Figure 4-7 ADF/DME Tuning Window
Tune the ADF:
1)
From the tuning window, turn the large
FMS
Knob
to highlight the ADF tuningeld.
2)
Turn the small
FMS
Knob to enter the first digit.
3)
Turn the large
FMS
Knob to select the next desired
digit field. Turn the small
FMS
Knob to again
select the desired digit.
4)
When the desired frequency is entered press the
ENT
Key to transfer the frequency into the active
field.
5)
Turn the large
FMS
Knob to select the MODE field.
Turn the small
FMS
Knob to select ADF or BFO.
6)
Turn the large
FMS
Knob to select the volume
eld if desired. Turn the small
FMS
Knob to adjust
the ADF volume to the desired level.
7)
Press the
FMS
Knob to exit all theelds.
Seitenansicht 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 227 228

Kommentare zu diesen Handbüchern

Keine Kommentare