Garmin Software Version 0719.00 Betriebsanweisung PDF herunterladen (Seite 17)

Garmin G1000 Cockpit Reference Guide for the Socata TBM 850

190-00708-00 Rev. A

1-3

SECTION 1

SYSTEM OVERVIEW

The following list provides an overview of the

controls located on the PFD bezel (see Figure 1-1).

1

NAV VOL/ID Knob

– Controls NAV audio

volume level. Press to switch the Morse code

identiﬁer audio ON and OFF. Volume level

is shown in the NAV frequency ﬁeld as a

percentage.

2

NAV Frequency Transfer Key

– Switches the

standby and active NAV frequencies.

3

Dual

NAV Knob

– Tunes the standby frequencies

for the NAV receiver (large knob for MHz; small

knob for kHz). Press to switch the tuning box

(light blue box) between NAV1 and NAV2.

4

Joystick

– Changes the map range when rotated.

Activates the map pointer when pressed.

5

BARO Knob

– Sets the altimeter barometric

pressure. Press to enter standard pressure

(29.92).

6

Dual COM Knob

– Tunes the standby

frequencies for the COM transceiver (large knob

for MHz; small knob for kHz). Press to switch

the tuning box (light blue box) between COM1

and COM2.

7

COM Frequency Transfer Key

– Switches the

standby and active COM frequencies. Press

and hold this key for two seconds to tune the

emergency frequency (121.5 MHz) automatically

into the active frequency ﬁeld.

8

COM

VOL/SQ Knob

– Controls COM audio

volume level. Volume level is shown in the

COM frequency ﬁeld as a percentage. Press to

turn the COM automatic squelch ON and OFF.

9

Direct-to Key ( )

– Allows the user to

enter a destination waypoint and establish a

direct course to the selected destination (the

destination is either speciﬁed by the identiﬁer,

chosen from the active route, or taken from the

map pointer position).

10

FPL Key

– Displays the active Flight Plan Page

for creating and editing the active ﬂight plan.

11

CLR

Key

– Erases information, cancels entries,

or removes page menus.

12

Dual FMS Knob

– Flight Management System

Knob. Press the

FMS

Knob to turn the selection

cursor ON and OFF. When the cursor is ON,

data may be entered in the applicable window

by turning the small and large

knobs. The large

knob moves the cursor on the page, while the

small

knob selects individual characters for the

highlighted cursor location.

13

MENU Key

– Displays a context-sensitive list

of options. This list allows the user to access

additional features or make setting changes that

relate to particular pages.

14

PROC Key

– Gives access to IFR departure

procedures (DPs), arrival procedures (STARs)

and approach procedures (IAPs) for a ﬂight plan.

If a ﬂight plan is used, available procedures

for the departure and/or arrival airport are

automatically suggested. These procedures can

then be loaded into the active ﬂight plan. If a

ﬂight plan is not used, both the desired airport

and the desired procedure may be selected.

15

ENT Key

– Validates or conﬁrms a menu

selection or data entry.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 227 228

Kommentare zu diesen Handbüchern

Keine Kommentare