
Garmin G1000 Cockpit Reference Guide for the DA42
190-00406-05 Rev. B
SECTION 6 – AUTOMATIC
FLIGHT CONTROL
6-9
6.5 ROLL AXIS MODES
Mode annunciations for active roll axis modes are
shown in green during normal operation.
AFCS
Key
AFCS Mode Annunciation
FD/AP only Roll Hold (Default) ROL
HDG Heading Select HDG
NAV
VOR Enroute
Arm/Capture/Track
VOR
GPS Arm/Capture/Track GPS
BC Arm/Capture/Track BC
LOC Arm/Capture/Track;
(No Glideslope)
LOC
APR
GPS Arm/Capture/Track
GPS
VOR Approach
Arm/Capture/Track
VAPP
ILS Approach
Arm/Capture/Track
(Glideslope Mode
automatically armed)
LOC
GA Go Around (Wings Level) GA
The default roll axis mode is Roll Hold (ROL). When
no other roll axis modes are selected, this is the active
roll axis mode when the autopilot and/or flight director
is engaged.
Roll Hold Mode (ROL)
1) Press the
FD
or
AP
Key.
If the aircraft bank angle is ≥ 6˚ when the
key is pressed, Roll Hold Mode is selected by
default. Roll attitude at the time of activation
is maintained by the autopilot up to 22˚. If
only the flight director is active, command bars
indicate the proper roll attitude.
If the aircraft bank angle is
< 6˚ when the key
is pressed, the aircraft will be maintained at
wings level. If only the flight director is active,
command bars give guidance to maintain
wings level.
Roll Hold Mode is annunciated by ‘ROL’.
Figure 6-16 Roll Hold Mode
2) A new heading can be established by pressing
and holding the
CWS
Button and manually
turning the aircraft to the desired new heading.
Release the
CWS
Button and the aircraft will
maintain wings level at approximately the new
heading, but will not hold the heading. The
same practice applies to holding roll attitude.
Kommentare zu diesen Handbüchern