Garmin Software Version 0370.17 Betriebsanweisung PDF herunterladen (Seite 112)

Garmin G1000 Cockpit Reference Guide for the DA42

190-00406-05 Rev. B

10-22

SECTION 10 – HAZARD

AVOIDANCE

Sector Scan

1) While in horizontal scan mode, select the BRG

Softkey to display the Bearing Line and place the

cursor in the BEARING ﬁeld (Figure 10-35).

If the Bearing Line is not displayed, press the

MENU Key and turn the large

FMS Knob to select

‘Show Bearing Line’. Press the ENT Key.

Figure 10-35 Selecting Sector Scan Position

2) Turn the small

FMS Knob to place the Bearing Line

in the desired position. The location of the Bearing

Line will become the center point of the Sector

Scan.

3) Turn the large

FMS Knob to place the cursor in the

SECTOR SCAN ﬁeld.

4) Turn the small

FMS Knob to select FULL, 60˚, 40˚,

or 20˚ scan.

5) If desired, readjust the

Bearing Line as discussed

previously to change the center of the Sector Scan.

6) Select the

BRG Softkey again to remove the Bear-

ing Line and cursor. The bearing reference will also

be reset to 0º.

Figure 10-36 40˚ Sector Scan

Antenna Stabilization

1) To activate or deactivate the antenna stabilization,

select the MODE Softkey.

2) Select the STAB ON Softkey to activate

antenna

stabilization or select the STAB OFF Softkey to

deactivate. The current stabilization condition is

shown in the upper right of the weather radar

display.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 141 142

Keine Kommentare

Garmin Software Version 0370.17 Betriebsanweisung Seite 112