Garmin 2006T Betriebsanweisung Seite 315

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 348
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 314
190-01146-00 Rev. A
Garmin G950 Pilot’s Guide for the Tecnam P2006T
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
303
APPENDIX A
Message Comments
ABORT APR
– Loss of GPS navigation.
Abort approach.
Abort approach due to loss of GPS navigation.
APR DWNGRADE
Approach
downgraded.
Vertical guidance generated by WAAS is unavailable, use LNAV only minimums.
TRUE APR
True north approach.
Change HDG refereence to TRUE.
Displayed after passing the first waypoint of a true north approach when the nav angle is
set to AUTO’.
GPS1 SERVICE
– GPS1 needs service.
Return unit for repair.
A failure has been detected in the GPS1 and/or GPS2 receiver. The receiver may still
be available. The G950 system should be serviced.
GPS2 SERVICE
– GPS2 needs service.
Return unit for repair.
NAV1 SERVICE
– NAV1 needs service.
Return unit for repair.
A failure has been detected in the NAV1 and/or NAV2 receiver. The receiver may still
be available. The G950 system should be serviced.
NAV2 SERVICE
– NAV2 needs service.
Return unit for repair.
NAV1 RMT XFR
– NAV1 remote
transfer key is stuck.
The remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or “pressed”)
state. Press the transfer switch again to cycle its operation. If the problem persists,
the G950 system should be serviced.
NAV2 RMT XFR
– NAV2 remote
transfer key is stuck.
G/S1 FAIL
– G/S1 is inoperative.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The G950
system should be serviced.
G/S2 FAIL
– G/S2 is inoperative.
G/S1 SERVICE
– G/S1 needs service.
Return unit for repair.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The receiver
may still be available. The G950 system should be serviced when possible.
G/S2 SERVICE
– G/S2 needs service.
Return unit for repair.
GTX 33 MESSAGE ADVISORIES
Message Comments
XPDR1 CONFIG
– XPDR1 config error.
Config service req’d.
The transponder configuration settings do not match those of backup configuration
memory. The G950 system should be serviced.
MANIFEST
– GTX1 software
mismatch, communication halted.
The transponder has incorrect software installed. The G950 system should be
serviced.
XPDR1 SRVC
– XPDR1 needs service.
Return unit for repair.
The #1 transponder should be serviced when possible.
XPDR1 FAIL
– XPDR1 is inoperative. There is no communication with the #1 transponder.
Seitenansicht 314
1 2 ... 310 311 312 313 314 315 316 317 318 319 320 ... 347 348

Kommentare zu diesen Handbüchern

Keine Kommentare