Garmin GPS 65 Bedienungsanleitung PDF herunterladen (Seite 27)

• Move the cursor to the latitude hemispheric designator with the

arrow keys. PressCLRifyouneedtochai^thisdesignatorfrom

“S” to “TT. Press ENT.

' With the cursor on the latitude d^rees, press “3” and then

ENT. (You may need to enter for minutes and/or seconds to

dear these fields, if they are shown.)

- Move the cimsor to the longitude hemispheric designator. Follow

the same sequence as above to complete longitude entry.

NOTE: The sample illustrations in this section assume that the factory

default settii^, including the selection ofnautical units (knots, nautical

miles), have not been changed. If these settings have been changed, the

unit may display sightly different data than presented here. Charging

the unit set-ups is covered later in Chapter 6.

Check the GARMIN waypoint«.

To verify that the “GARMIN”

waypoint is in memory, press WPT

to select a waypoint page.

If the Waypoint list Page is not

displayed, press the LIST softkey

to select it. Verify that the

waypoint, “GARMIN”, is on the

list. If it is, you may skip the next

three steps. NOTE: If the

Waypoint List Рг^ is full, use the

arrow keys to scroll through the

rest of the list until you locate the

“GARMIN” waypoint.

If the “GARMIN” wa)rpomt is not

listed, you must add it to the GPS

65's memory before you can

activate the GOTO fimction. E*ress

the WPT softkey.

Move the cursor over the waypoint

name field with the arrow keys.

Enter “G”, “A”, “R”, “M”, “Г, “N”.

Press ENT. Remember to use tiie

arrow keys to select the letter you

3-13

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 75 76

Keine Kommentare

Garmin GPS 65 Bedienungsanleitung Seite 27