
Garmin G1000 Cockpit Reference Guide for the Diamond DA62
190-01896-00 Rev. A 101
Annunciations & Alerts
Flight
Instruments EIS
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation
Annun/
Alerts Appendix Index
DATABASE MESSAGE ADVISORIES (CONT.)
Message Comments
MFD1 DB ERR
– MFD1 FliteCharts
database error exists.
The MFD and/or PFD detected a fault in the
FliteCharts database (optional feature). Ensure
that the data card is properly inserted. Replace
data card. If problem persists, The system should
be serviced.
MFD1 DB ERR
– MFD1 Airport
Directory database error exists.
The MFD detected a fault in the Airport Directory
database. Ensure that the data card is properly
inserted. Replace data card. If problem persists, the
system should be serviced.
MFD1 DB ERR
– MFD1 multiple
database errors exist.
The MFD and/or PFD detected a fault in more than
one database. If problem persists, the system
should be serviced.
PFD1 DB ERR
– PFD1 multiple
database errors exist.
DB MISMATCH
– Navigation
database mismatch. Xtalk is off.
The PFD and MFD have different navigation
database versions or regions installed. Crossfill
is off. Check the AUX-SYSTEM STATUS Page
to determine versions or regions. Also, check
the AUX-SYSTEM STATUS Page for a database
synchronization function not completed. After
synchronization is complete, power must be turned
off, then on.
DB MISMATCH
– Standby
Navigation database mismatch.
The PFD and MFD have different standby navigation
database versions or regions installed. Check the
AUX-SYSTEM STATUS Page to determine versions
or regions. Also, check the AUX-SYSTEM STATUS
Page for a database synchronization function not
completed. After synchronization is complete,
power must be turned off, then on.
DB MISMATCH
– Terrain database
mismatch.
The PFD and MFD have different terrain database
versions or regions installed. Check the AUX-
SYSTEM STATUS Page to determine versions or
regions. Also, check the AUX-SYSTEM STATUS
Page for a database synchronization function not
completed. After synchronization is complete,
power must be turned off, then on.
Kommentare zu diesen Handbüchern