Garmin GPS 158 Bedienungshandbuch PDF herunterladen (Seite 10)

10 GPS 158 Owner’s Manual



Remove the 10 mm M6×1 Phillips screw ➊ and separate the swivel mount ➋

from the base

➌�

➌

➋

➊

➍



If you plan to route the cables from under the mounting surface, orient the base

so the pass-through holes

➍ face the desired direction�



Using the base as a template, mark the pilot hole locations ➎�

➎

➏



If you plan to route the cables from under the mounting surface, mark the

location in the center

➏�



Using the appropriate drill bit for the hardware, drill the three pilot holes�



If you plan to run the power and transducer cables from under the mounting

surface, use a

in� (16 mm) drill bit to drill a hole through the mounting surface

at the location you marked in step 5�



Follow these steps only if you do not need to run the cables through the mounting

surface and the swivel mount�



Place the base ➊ on the mounting surface, and fasten it using the appropriate

screws or bolts

➋�

➋

➊



Place the swivel mount on the base, and replace the 10 mm M6×1 Phillips

screw�



Seal the cable pass-through holes with marine sealant�

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Garmin GPS 158 Bedienungshandbuch Seite 10