
FAA APPROVED AIRPLANE FLIGHT MANUAL SUPPLEMENT
GARMIN G1000 INTEGRATED AVIONICS SYSTEM
DIAMOND MODEL DA 40
DIAMOND MODEL DA 40 F
190-00492-11 Rev 8 Diamond DA 40 / DA 40F
4A-1
SECTION 4A
NORMAL PROCEDURES
NOTE
Readability of the PFD and MFD displays may be degraded when wearing
polarized sunglasses.
1. DETAILED OPERATING PROCEDURES
Normal operating procedures for the G1000 are described in the Garmin
G1000 Cockpit Reference Guide and the Garmin G1000 Pilot's Guide.
PRE-FLIGHT INSPECTION
I. Cabin check
a) MET, NAV, Mass & CG ........................................ flight planning complete
b) Airplane documents .................................................. complete and up-to-date
c) Ignition key ..................................................................................... pulled out
d) Front canopy & rear door ...................................................clean, undamaged
e) All electrical equipment ........................................................................... OFF
f) Circuit breakers ......................... set in (if one has been pulled, check reason)
g) Engine control levers ........................ check condition, freedom of movement
...................................................................................... Full travel of throttle,
................................................................. Full Travel of RPM (DA 40 only)
............................................................................ Full Travel of mixture lever
h) Throttle .................................................................................................. IDLE
i) Mixture control lever ............................................................................ LEAN
j) RPM lever (DA 40 only) ............................................................. HIGH RPM
k) Carburetor Heat (DA 40 F only) ......................................................... COLD
l) BAT (battery) switch ................................................................................ ON
m) Fuel Quantity ............................................................... check fuel qty. on EIS
................................................................... check with fuel qty. measuring device
Kommentare zu diesen Handbüchern