Garmin SA01933LA_D Bedienerhandbuch PDF herunterladen (Seite 27)

Instructions for Continued Airworthiness G600, GNS 530W, GNS 430W, 190-01080-05 Rev. 2

GMA 347, GTX 330D, GMX 200, WSI AV-200 Cessna 208/208B Page 27 of 29

5. Tin the center conductor. Flair the outer shield braid by gently rotating the center conductor and

dielectric, then finish to flare out, taking care not disturbing the inner foil shield. Do not remove

the inner foil shield from the dielectric.

6. Insert the cable into the rear of the connector body. The inner foil shield goes inside the

connector body and the braid shield goes outside the connector body, with the center conductor

going directly into the contact slot, until the cable insulator buts against the contact.

7. Solder the center conductor to the contact. Do not exceed specified solder temperatures in Table

A-1

8. Slide the crimp tube over the braid up against connector body. Crimp using the tooling specified

in Table A-1

9. Affix the o-ring to the access cap, thread the access cap onto the connector body and tighten.

Install black adhesive heat shrink into place past crimp tube and up over connector body and heat

shrink into place.

10. Reattach the connector to the corresponding transponder antenna.

11. Perform function checks as specified in section 2.5.1.

Termination Instructions, 180° Connector (Ref Emteq Dwg ES-105-7):

1. Disconnect faulty connector from lower transponder antenna or transponder rack. Cut the

connector off completely using snips or diagonal cutters. Make every attempt to limit the amount

of cable which is removed along with the connector.

NOTE:

For proper transponder diversity performance,

all four cables must be within 12 inches total length of each other.

2. Slide on heat shrink label, black adhesive heat shrink, and crimp tube. Installer is responsible for

remaking cable labels. Use existing cable label as a reference.

3. Strip the cable insulation according to the following diagram:

4. Install cable insulator onto center conductor butting it up against cable dielectric, as shown:

1 2 ... 22 23 24 25 26 27 28 29

Keine Kommentare

Garmin SA01933LA_D Bedienerhandbuch Seite 27