Garmin TR-1 Bedienerhandbuch PDF herunterladen

906-1129-00 Ver 03

Cylinder and Bracket

Mounting Instructions

Mercury 9.9 Bigfoot 2005 and Newer

TR-1 Gold

1 2 3 4 5 6 7 8 9

Inhaltsverzeichnis

Seite 1 - TR-1 Gold

906-1129-00 Ver 031Cylinder and BracketMounting InstructionsMercury 9.9 Bigfoot 2005 and NewerTR-1 Gold

Seite 2

Parts:Item NumberPart Number Name Qty.1 330-1121-00 Standoff, Spacer 22 130-1127-00 Bracket, Rod Eye Mounting 13 330-1003-00 Pin, Stern Pivot 14 380-1

Seite 3 - Tools Needed:

3Tools Needed3/8” Ratchet and extension with 1/4” adapter#3 Phillips Screw DriverLoctite or Similar Thread Locking Compound End WrenchTorque WrenchT

Seite 4 - Rod Eye Bracket

Step One: Install U-bolt and Rod Eye Bracket.Install the Rod eye Bracket (item 2) by using the U-Bolt (item 16), split wash-ers (item 14) and the nuts

Seite 5 - Step Two: Install Standoffs

Step Two: Install Standoffs and Channel Bracket.Remove the lower bolt on the shroud as shown in Figure 3 & 4. Using the bolts from the cylinder

Seite 6

Remove the upper bolt from the shroud, See Fig-ure 6. Install the second standoff spacer (item 1). Insert the bolt (item 17) through the lock washer

Seite 7

Figure 9Figure 10Figure 11Step Three: Install Snubber and Screw.Slip the snubber clip (item 5) behind the channel and up against the shroud as shown

Seite 8 - Step Six: Cylinder End Cap

Figure 12Figure 13Step Four: Cylinder Rod EyePlace the Rod Eye (item 31) over the vertical pin in the Rod Eye Mounting Bracket (item 2) as shown in F

Seite 9 - Step Seven (Full Port &

Figure 16Figure 17Step Seven (Full Port & Starboard):Turn the motor hard over to port. That will retract the Cylinder rod into the Cylinder, see